Dlicious,

got the diagram,.. thanks!!

gotta get this thing running before I get the pics up!! LOL

the needle seat valve is the old one, and is clear. The float is what I suspect, but I am not sure.

I am going to disassemble both of them side by side, and see what the differences are. I think the float may need to be adjusted, and since the righty is good, I hope to match up the lefty.

yes, this started after I did the rebuild.

my float has a hole in it..... anybody have a spare float for a 40 Kadron??

I got one from Kermit. I'd check with him before ordering online and paying for shipping. You may be able to solder it too.

Kostya is the Kadron guru round these parts

Here was the deal!!

Went to Kermit and got the new float! Thanks on that one!!

The needle seat valve was not closing when the float reached the top! I spoke with Peter Rasmussen, and he advised that I add more washers until the match made in heaven was reached. A few extra washers later and WALLAH!!! I am in business again!!

Now I need to replace my throttle cable, as it broke on the test run!! LOL GOTTA LOVE IT!! Got the cable at Bap for 3 bucks, should be rolling by midnight!! LOL!!!

Thanks again for all the advice!!

This baby is purring now!! Looking for a used 009 now to replace the vaccum advance one that I don't need, but am using!!

Let me know if you have one, or want to trade??!!

Peace out Fellas