| der Luftkühlers http://www.dlkweb.org/phpBB3/ |
|
| Cutting out when Braking (hot) http://www.dlkweb.org/phpBB3/viewtopic.php?f=10&t=6363 |
Page 1 of 1 |
| Author: | thingmon [ Sun Aug 17, 2014 9:43 pm ] |
| Post subject: | Cutting out when Braking (hot) |
Here's a fun one for you all. Beetle with a AH code 1600 dual port, PICT 34, 009, points and condenser, and blue coil. Points appear to be right ~45, idle up a bit at ~1000, timed to ~30 deg at full advance. Started cutting out and idling rough so I reset the points and upped the idle a bit to the above. Cleaned up the rotor and contacts inside the cap. Seemed to clear things up but still cuts out during hard stops, but only when hot. Still need to try new points, cap and rotor, etc... May swap in my spare electronic ignition to see if that makes any difference. Thoughts? |
|
| Author: | ConcreteAce [ Sun Aug 17, 2014 10:35 pm ] |
| Post subject: | Re: Cutting out when Brakeing (hot) |
I think I would completely swap the dizzy and give it a whirl, that would narrow down if its the dizzy |
|
| Author: | RyanW [ Sun Aug 17, 2014 11:08 pm ] |
| Post subject: | Re: Cutting out when Brakeing (hot) |
Check the wires on your coil far a good connection. We found that to be the issue when Reds car was doing almost the same thing, the wire was loose in the connector and it would cut out when it wiggled a little. |
|
| Author: | Redjames [ Mon Aug 18, 2014 10:39 am ] |
| Post subject: | Re: Cutting out when Brakeing (hot) |
RyanW wrote: Check the wires on your coil far a good connection. We found that to be the issue when Reds car was doing almost the same thing, the wire was loose in the connector and it would cut out when it wiggled a little. Yep, it happen to me. check the wire on coil and make sure the wire connection is good. |
|
| Author: | Boom [ Tue Aug 19, 2014 4:58 am ] |
| Post subject: | Re: Cutting out when Brakeing (hot) |
I would suggest checking the ground strap on the trans mount. |
|
| Author: | thingmon [ Wed Aug 27, 2014 11:17 pm ] |
| Post subject: | Re: Cutting out when Brakeing (hot) |
Ok, I'll give those ideas a try. Wish me luck! |
|
| Author: | thingmon [ Thu Sep 18, 2014 9:56 pm ] |
| Post subject: | Re: Cutting out when Brakeing (hot) |
Turned out to be a loose condenser... Thanks Nick. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|