The one on the pasenger side on the throw out bearing shaft?
| der Luftkühlers http://www.dlkweb.org/phpBB3/ |
|
| How do you get the brass bushing out? http://www.dlkweb.org/phpBB3/viewtopic.php?f=11&t=2945 |
Page 1 of 1 |
| Author: | RyanW [ Tue Dec 15, 2009 9:39 pm ] |
| Post subject: | How do you get the brass bushing out? |
The one on the pasenger side on the throw out bearing shaft?
|
|
| Author: | Chris P [ Tue Dec 15, 2009 9:58 pm ] |
| Post subject: | Re: How do you get the brass bushing out? |
Grind it out carefully... |
|
| Author: | RyanW [ Tue Dec 15, 2009 10:31 pm ] |
| Post subject: | Re: How do you get the brass bushing out? |
I thought of that, why did you not say that when you were over here? There has to be another way or a tool. |
|
| Author: | Chris P [ Tue Dec 15, 2009 10:37 pm ] |
| Post subject: | Re: How do you get the brass bushing out? |
RyanW wrote: I thought of that, why did you not say that when you were over here? There has to be another way or a tool. After thinking about it on the way home, I figured the only way to get it out was to grind it out with a Dremel till it gets thin enough to collapse it/drag it out. |
|
| Author: | Boom [ Wed Dec 16, 2009 6:01 am ] |
| Post subject: | Re: How do you get the brass bushing out? |
if its a blind hole bushing they do make removal tools for most |
|
| Author: | 69vduber [ Wed Dec 16, 2009 6:38 am ] |
| Post subject: | Re: How do you get the brass bushing out? |
I have a Dremal but may not have the right grider bit. If you need it. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|