der Luftkühlers http://www.dlkweb.org/phpBB3/ |
|
Grinding when going into gear http://www.dlkweb.org/phpBB3/viewtopic.php?f=11&t=4200 |
Page 1 of 1 |
Author: | gostros [ Fri May 27, 2011 8:32 am ] |
Post subject: | Grinding when going into gear |
What would cause grinding when going into first or reverse? Also, it's hard to get the car into gear - but it doesn't pop out once in gear. Is it simply a clutch cable adjustment? |
Author: | beetleluvr [ Fri May 27, 2011 9:22 am ] |
Post subject: | Re: Grinding when going into gear |
gostros wrote: What would cause grinding when going into first or reverse? Also, it's hard to get the car into gear - but it doesn't pop out once in gear. Is it simply a clutch cable adjustment? Have you tried adjusting the shifter plate to the floor pan? It could be that it is not in its correct location. |
Author: | Boom [ Fri May 27, 2011 9:43 am ] |
Post subject: | Re: Grinding when going into gear |
sOunds like clutch |
Author: | Chris P [ Fri May 27, 2011 10:12 am ] |
Post subject: | Re: Grinding when going into gear |
Could be fluid; have you changed the fluid and is it full? Could be clutch adjustment; is there about 1.5" of play? As Ben has stated; is the shifter adjusted properly? What about the shift rod bushing and shift rod coupling? have those been inspected and changed if needed? |
Author: | gostros [ Fri May 27, 2011 11:32 am ] |
Post subject: | Re: Grinding when going into gear |
Chris P wrote: Could be fluid; have you changed the fluid and is it full? Could be clutch adjustment; is there about 1.5" of play? As Ben has stated; is the shifter adjusted properly? What about the shift rod bushing and shift rod coupling? have those been inspected and changed if needed? I don't know to all of these. This is a good place to start, thanks guys! |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |