der Luftkühlers http://www.dlkweb.org/phpBB3/ |
|
IRS wheel bearings... http://www.dlkweb.org/phpBB3/viewtopic.php?f=13&t=6245 |
Page 1 of 1 |
Author: | Chisel_86 [ Mon Apr 14, 2014 9:35 am ] |
Post subject: | IRS wheel bearings... |
To change the IRS (rear) wheel bearings, do you need to remove the stub axle from the arm? |
Author: | Chisel_86 [ Mon Apr 14, 2014 11:05 am ] |
Post subject: | Re: IRS wheel bearings... |
Looks like it. Dang. Thanks Wayne. |
Author: | Boom [ Mon Apr 14, 2014 3:50 pm ] |
Post subject: | Re: IRS wheel bearings... |
Post up some pics. I haven't had any experience with late model suspensions. |
Author: | Chisel_86 [ Mon Apr 14, 2014 4:13 pm ] |
Post subject: | Re: IRS wheel bearings... |
I've been hearing a whirring/slight groaning noise durring decelleration and on freeway ramps while turning left. No noticable noise at slow speeds. Wayne had suggested that it may be the CV's or the bearings. I know my axle nuts are tight. It sounds like too much to do before the classic so I am going to just take it easy. It's not a horrible noise. What I think I'll do, is buy new bearings in case I need them, and install new 944 axle shafts when I do my conversion sometime in the future. I have all the other parts I need. I'll post up when I get around to working on it. |
Author: | Chisel_86 [ Mon Apr 14, 2014 7:17 pm ] |
Post subject: | Re: IRS wheel bearings... |
Upon further diagnosis, I believe the sound is coming from the front passenger side. Noticeable from 45mph and up. Now I have already checked the bearings and hub up there since I was having other brake issues. I will have to check the rest of the suspension. I'm quite baffled about this now. It does it when I'm slowing down and also when turning left... |
Author: | Fitz [ Mon Apr 14, 2014 7:30 pm ] |
Post subject: | Re: IRS wheel bearings... |
I had a noise like that in my 69. Turned out to be the cv. |
Author: | Chisel_86 [ Mon Apr 14, 2014 8:31 pm ] |
Post subject: | Re: IRS wheel bearings... |
I need a pro with good ears to ride along with me. |
Author: | Chisel_86 [ Tue Apr 15, 2014 3:37 pm ] |
Post subject: | Re: IRS wheel bearings... |
Still stumped about this. I've repacked and tightened the front bearings and replaced the pads. Could an over-tightened rear axle nut cause this? |
Author: | Chisel_86 [ Tue Apr 15, 2014 6:35 pm ] |
Post subject: | Re: IRS wheel bearings... |
I've decided to drain and refill the trans fluid. It couldn't hurt since I've never done it... (Ducks head down in shame...) |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |