der Luftkühlers
http://www.dlkweb.org/phpBB3/

Rear Diagonal Arm Bearing Race
http://www.dlkweb.org/phpBB3/viewtopic.php?f=18&t=6667		 Page 1 of 1
Author:  techmo82 [ Sun Sep 27, 2015 7:09 pm ]
Post subject:  Rear Diagonal Arm Bearing Race
Hi,
One of my IRS Diagonal arms had some smelly dirty bearings, noticed after I got the axle removed. I got the entire hub torn down and cleaned. Noticed that the race appears to have an extra "groove" in it. Almost like the roller bearings started riding into the race. Anyone seen such a thing? Not sure if I should replace this arm or go ahead and press in a new bearing and let it ride. Can see discoloration on the race. Not sure what the best remedy is for such a hub.
Nick

Attachments:
FullSizeRender (2).jpg
FullSizeRender (2).jpg [ 1.82 MiB | Viewed 511 times ]
Author:  ConcreteAce [ Sun Sep 27, 2015 7:37 pm ]
Post subject:  Re: Rear Diagonal Arm Bearing Race
I have no knowledge of IRS but I have replaced the races before in a few drums on my dump trailer, the races has saved me a ton of money over the years because when the bearing goes bad and cuts groves in them I am able to replace them with no problems and not have to buy a new drum.
Author:  bruce72 [ Wed Sep 30, 2015 7:09 pm ]
Post subject:  Re: Rear Diagonal Arm Bearing Race
I got a couple arms if you need one just let me know I replaced the bearing and races on one before but don't remember it looking like that. If your local and want to come look at the arms I got we can see if they look different and if not just replace your races.
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/