As dad would say "measure twice cut once"
| Attachments: |
| IMG_4142.PNG [ 1.57 MiB | Viewed 262 times ] |
| der Luftkühlers http://www.dlkweb.org/phpBB3/ |
|
| 36hp clown college engine build http://www.dlkweb.org/phpBB3/viewtopic.php?f=39&t=6894 |
Page 3 of 10 |
| Author: | mk-Zero [ Fri Jun 16, 2017 8:18 pm ] |
| Post subject: | Re: 36hp clown college engine build |
| Author: | The_Half_Bus [ Sun Jun 18, 2017 11:38 am ] | ||
| Post subject: | Re: 36hp clown college engine build | ||
As dad would say "measure twice cut once"
|
|||
| Author: | The_Half_Bus [ Sun Jun 18, 2017 1:30 pm ] | |||
| Post subject: | Re: 36hp clown college engine build | |||
Test fit
|
||||
| Author: | mk-Zero [ Mon Jun 19, 2017 10:11 am ] |
| Post subject: | Re: 36hp clown college engine build |
Looking good! Keep it up!  Having a hard time figuring out your measurement sheet. Did you measure the bearings and journals each at a few locations? I usually measure them every 90 degrees (4 measurements per bearing/journal). Sometimes the bearings can be a little out of round and be tight in one area, and you can miss it if you only take a single measurement. I like at least .003" minimum oil clearance between the tightest location on the bearing and the largest diameter of the journal. Also, it's important to measure the bearings in the case, with the case halves torqued down. The bearings are designed with a few thou of "crush" in them, so unless you measure them in a torqued down case your measurements are fairly useless. |
|
| Author: | The_Half_Bus [ Mon Jun 19, 2017 10:12 am ] | ||
| Post subject: | Re: 36hp clown college engine build | ||
|
|||
| Author: | oval1 [ Tue Jun 20, 2017 7:31 pm ] |
| Post subject: | Re: 36hp clown college engine build |
My 1500cc 1950 25hp  Destination Looking good Eric  
|
|
| Author: | mk-Zero [ Tue Jun 20, 2017 8:41 pm ] |
| Post subject: | Re: 36hp clown college engine build |
That's pure vintage speed porn Eliot! What kind of heads? |
|
| Author: | The_Half_Bus [ Wed Jun 21, 2017 10:17 am ] |
| Post subject: | Re: 36hp clown college engine build |
oval1 wrote: My 1500cc 1950 25hp Destination Looking good Eric INCREDIBLE!!! Love it! |
|
| Author: | 69vduber [ Thu Jun 22, 2017 10:41 am ] |
| Post subject: | Re: 36hp clown college engine build |
oval1 wrote: My 1500cc 1950 25hp Destination Looking good Eric Coming home with that? 
|
|
| Author: | tommiebsmith [ Mon Jun 26, 2017 3:38 pm ] |
| Post subject: | Re: 36hp clown college engine build |
Pretty awesome
|
|
| Page 3 of 10 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|