We're not going bigger right now, but yeah the needle is still bouncing around. Usually it's intermittent, but today it was doing it the whole time, so I just unplugged it.

Did you check to see if you have any wires that might have been nicked or cut??? Are there any spliced wire since they don't give you enough wire? If so what gauge of wire are you using??

No I haven't check all that yet, and not sure of the gauge of wire I used. I'll be pulling the motor this week anyways, so I'll re-run the wires.

This morning Andrey and I pulled the motor, and then Brian came over to split the case and take a look at everything. Here are some pictures Nina took.

Virgin 1600

Can't wait to see it back together, and hear it run

So how did things look when you split the case? Looks like things are gonna be nice and clean when you put it back together.

Way to attack that. Looks like you had fun cleaning things up.

What was up with the engine?

Every looked unmolested, and all the bearing were standard size.

The engine had low compression, and was blowing out plumes of white smoke.