Here are your fenders Bro!



I think they look better on my car

Dang bro, looking good. Thanks again Jeff.

No prob, maybe it'll make up for my job forcing me to flake out on our work day on Sun

So nothing major to report. Did get the spring plates notched:


Also discussed doing this with Jeff and his hella cool neighbor Jared. Since I am doing the RHD convo, I was thinking of swapping over the brake line to run on the right. With that being done, I figured I would add a larger fuel line for a bigger motor when the time comes. With all that being done, here is the plan. I dont want to run it through the tunnel since it is a pain to do, and I have a few holes on the left side anyways.

So use one of these -6AN bulkhead fittings (one on each end):


And they will go here (where the screw driver is pointing):



And the new line would go along the pan in the old brake line position (where the torsion bar is):


As you can see I have to get the pan blasted to see how much more pan I have to cut out and replace

Running a hard line through the tunnel isn't a big deal, especially since you have the body off. I ran a 1/2" line through mine

Lookin good man, ready to do my springplates?

Cool, do you have any pics of how you used the AN hose fittings? I would like to see how you mounted them to the pan.

Thanks. Yeah, I can take care of your springplates as soon as you are ready.

does that go for me too..

Sure, just let me know when