I knew there were wiring differences between the 61 and later. I am switching to the 62 turn signal to match the harness.
That's one of the pictures I took during tear down. Soooo many pictures I guess I need organize them better At least this is simple section to make.
Thanks again Ethan

Just about finished up the wiring this weekend. Just got the tail lights to do.







I relocated the voltage regulator to under the rear seat. That is what I worked on today mostly. Rerouting the wiring and making a bracket.
[img]http://i1187.photobucket.com/albums/z393/JohnW2010/Kbug%2061/Wiring/DSCF0104.jpg[img]


Hopefully next week I'll finish up the tail lights and onto the doors. Question - How do you terminate the fender beading?

I would be interested in buying that 6 wire turn signal switch if you decide to sell it.

That grey color is looking great! What color interior?

Thanks

The original 6-wire switch was broken. The one in the picture is a 3-wire. I installed a '62 wiring harness to get around the one off '61 issues.

The interior is going to be red.

If you still have it, I would like it. I can use it for parts.

Red will look good....Ox Blood would be awesome. Its a deep red, but not maroon.

It yours, just send me your shipping address.
The seats will be blood red smoothie with ivory piping. The door cards will be two tone redtop/bottom and ivory center. Carpet is charcol with the headliner being the 3 piece off white.

Nice sounding combo! Glad you are not putting the one piece headliner in, the three piece looks so much better in earlier cars.

I may regret it since I will be the installer. But hey you just don't know until you try

not to get off tract ... but that is what I will end up doing ... I like the way it looks around the dome light etc . and the back.

Fender Beading - What is the proper way to terminate the ends?