Running board powder coating

freebird · **Posted:** Fri Oct 29, 2010 2:49 pm

oval1 wrote:

Nice!!! I was talking to Mike about doing that to the set off Peachy for his 60 Vert :thumbs:

You're right E!! That would look good!! Especially since they're powder coated and not just sprayed on. :beer:

Lostcauses,

That's awesome that you were able to get them hot enough to bake with that method!! :thumbs:

lostcauses · **Joined:** Sun Apr 13, 2008 10:15 am **Posts:** 336

Keep in mind this is a FLAMABLE product so do not use around open flame. Heres my bumper

oval1 · **Posted:** Fri Oct 29, 2010 6:22 pm

What are you using to keep the powder off the polished areas?

lostcauses · **Joined:** Sun Apr 13, 2008 10:15 am **Posts:** 336

Sometimes the heat tape but on these two projects I just wiped the highspots with a putty knife and puffed away the loose with a lite air blow.

EAnderson · **Posted:** Fri Oct 29, 2010 8:13 pm

Nice work

lostcauses · **Joined:** Sun Apr 13, 2008 10:15 am **Posts:** 336

Installed and off the ta-do list

Attachment:

008.JPG

Attachment:

002.JPG

Attachment:

004.JPG

freebird · **Posted:** Sat Oct 30, 2010 3:55 pm

Looks sharp, man!! :beer:

ConcreteAce · **Posted:** Sat Oct 30, 2010 10:41 pm

Very Nice!

notchback65 · **Posted:** Sun Oct 31, 2010 6:38 am

Nice!

lostcauses · **Joined:** Sun Apr 13, 2008 10:15 am **Posts:** 336

Cease's Garage went to powder coating CV joints axles and a master cylinder,which poroject car is yet to be seen