I did a once over every single solder joint on the board, should be good. Time to stuff it back into the car download the firmware to it.

I need to quit looking at that internet porn.

the guy I bought my led's from said to epoxy over the wires that are soldered maybe it would be a good idea to epoxy over all the connections to make sure they dont break?

I got some rubber mounts from MSD, and i'm going to conformal coat the board after I add the circuit for the launch control and shift light.

BTW- I figured it out and fixed it
i used the wrong ground for the throttle position sensor, everytime i stepped on the gas it caused a reset which caused all kinds of hell...yay me!

The car ran fantastic last night, only had a couple of hiccups. well this morning I had a interesting time starting it up, and then it ran like straight doo-doo plus i had a wheel fall off on the freeway. it wasn't that exciting since was still sitting on the hub. I'm being to wonder if its going to make the trip friday.

I'm off to FRY's to get a big cap to filter the noise from the alternator(I just got the alternator working a couple of days ago and this random drama with the resets started about the same time)...FML! I'm myself a big

How'd the wheel fall off?

WT%$#@ ...... wheels falling off...

I am beginning to think that it does not want to go to Fredricksburg

Damn dude, throw some carbs on there and be done with it!

I think the wheel fell off because it couldn't handle the type 4 torque

It would seem that this car really doesn't want to go, grrrr, because i really want to take it there.

Brian- The lawn mower is the only thing carbed at the ninja residence

So I added a couple of caps and so far it seems to have fixed the noise issues, but now its running super rich. hopefully a quick retune and i'll be good...i'm crossing my fingers.