Clay's 69

supaninja · **Posted:** Fri Oct 07, 2011 1:12 pm

Don't forget the wires to the horn and master cylinder :nono:

gostros · **Posted:** Fri Oct 07, 2011 1:41 pm

supaninja wrote:

Don't forget the wires to the horn and master cylinder :nono:

Don't forget the speedo cable (not sure if anyone mentioned that one yet).

69vduber · **Posted:** Fri Oct 07, 2011 4:23 pm

Starter wires and volt regif you have one.

Claymore · **Posted:** Fri Oct 07, 2011 7:50 pm

Progress made. The tear down started tonight. Hope to have the body off by the end of the weekend!

One of the female sockets on the body for the fender bolt was stripped out and fell into the body. Can I get that out!!?? Do I need to weld a new one in?

Extra picture of a treat that will go in on the build!

tommiebsmith · **Posted:** Fri Oct 07, 2011 7:55 pm

nice beam... is it getting a full inside out repaint?

ConcreteAce · **Posted:** Fri Oct 07, 2011 8:33 pm

Clay those nut inserts are pretty cheap and they weld right on.

60Mike · **Posted:** Fri Oct 07, 2011 9:24 pm

Clay,

If it were me, I'd leave the doors on. Or at least weld up some braces to prevent any flex if the heater channels are are bad.

69vduber · **Posted:** Sat Oct 08, 2011 3:40 am

My doors are on mine.. and it is on a stand. they don't weigh much.

Claymore · **Posted:** Sat Oct 08, 2011 5:00 am

Good to know about the insert! I did not see any rust when I was putting the interior in when i first got the car, but I will leave the doors in just to be safe. Yes, I am going for a full repaint.

fartfignewtons · **Posted:** Sun Oct 09, 2011 3:18 pm

Good job on starting the tear down.

How about getting your camera programed for the proper date so it is not off over half a decade! :hillbilly:

Clay's 69

Who is online